Studies on solvent extraction of iron(III) as a step for conversion of a waste effluent to a value added product

Solvent extraction of iron(III) from actual sulphate waste pickle liquor was investigated using trialkylphosphine oxide diluted with kerosene. The waste pickle liquor was procured from a local company which deals with the manufacturing of pipes and tubes made of iron and steel. Various parameters were studied to optimise a suitable condition for the maximum extraction of iron. The composition of the aqueous feed used in the experiment was 60.88 g/L Fe(III), 53 g/L acid with traces of Cu, Ni and Co. An ambient extraction at 30 °C yielded acceptable kinetics and loading efficiency for 40% trialkylphosphine oxide with a saturated loading capacity of 51.85 g/L in four contacts at O/A ratio of 1/1 in a multiple contact mode. Iron from the loaded organic was stripped using various strippants such as distilled water, H₂SO₄ and oxalic acid. Since only 32% of loaded Fe could be stripped with 2 M H₂SO₄ in five contacts, further stripping was done with 5% oxalic acid which showed a very promising result. It was found that almost 100% of Fe(III) could be stripped out with 5% oxalic acid at O/A of 1/1 in five contacts.     

Arsenic-safe alternate aquifers and their hydraulic characteristics in contaminated areas of Middle Ganga Plain, Eastern India

Arsenic groundwater contamination exceeding 0.05 mg/l affecting the Newer Alluvial tracts of Patna and Bhojpur, the two worst affected districts located in the Middle Ganga Plain in the Bihar state, has been studied The area is underlain by two-tier Quaternary aquifer systems within a depth of 300 m below ground level, separated by a 15?C32-m-thick clay/sandy clay aquitard. The upper part (<50 m depth) of the shallow aquifer system is arsenic-contaminated. The deeper aquifer system (lying below 120?C130 m depth) exhibits low arsenic load (max 0.0035 mg/l), having hydraulic conductivity between 64.88 and 82.04 m/day. Groundwater in the deeper aquifer occurs under semi-confined to confined condition due to poor hydraulic conductivity of the middle clay (4.7 × 10^???2???7.2 × 10^???3 m/day). Hydraulic head of the deeper aquifer remains close to the surface than the shallow aquifer. The two aquifer systems in the Newer Alluvium are replaced by a thick single aquifer system in the adjoining Older Alluvium, within a depth of 330 m below ground. In the arsenic-contaminated area, deeper aquifer is protected by a middle clay, which may be developed for community drinking water supply by deep tube wells having a yield capacity of 150 m³/h.     

Two-layer channel flow involving a fluid with time-dependent viscosity

Environmental Fluid Mechanics - A pressure-driven two-layer channel flow of a Newtonian fluid with constant viscosity (top layer) and a fluid with a time-dependent viscosity (bottom layer) is...     

Histopathological changes in liver of Heteropneustes fossilis exposed to cypermethrin

Cypermethrin was administered to Heteropneustes fossilis in chronic concentration to determine lesion of liver as indicators of tissue damage. The cypermethrin dose used was 1/4 of 96 hr LC50. Histopathological changes in liver ranged from vacuolization, necrosis, fibrosis of perivascular region and disposition of yellow brown grains at different time of exposure viz; 20th, 30th, 40th and 60th days.     

Partial purification and anti-leukemic activity of L-asparaginase enzyme of the actinomycete strain LA-29 isolated from the estuarine fish, Mugil cephalus (Linn.)

The actinomycete strain LA-29 isolated from the gut contents of the fish, Mugil cephalus of the Vellar estuary showed excellent L-asparaginase activity The enzyme was purified 18-fold and the final recovery of protein was 1.9%, which exhibited an activity of 13.57 IU/mg protein. The partially purified L-asparaginase inhibited the growth of leukemia cells in male wistar rats. Average survival period of the rats was more in an optimum enzyme dose of 100 units and the survival period was less when the dosages were increased and at the same time the enzyme became less effective when the dosages were decreased. Higher survival of 17.2 days was recorded when 100 units of the enzyme was given in three intermittent doses (50/25/25 units) at the interval of 24 hr. Analysis of cell components of the strain LA-29 has revealed the wall type-I which is the characteristic of the genus Streptomyces. Further the morphological, physiological and biochemical features along with the micromorphological results obtained for the strain LA-29 were compared with that of the Streptomyces species found in Bergey's Manual of Determinative Bacteriology and the strain LA-29 has been tentatively identified as Streptomyces canus.     

Assessment of drain water receiving effluent from tanneries and its impact on soil and plants with particular emphasis on bioaccumulation of heavy metals

In the present study, impact of tannery and other industrial effluents on the physico-chemical characteristics of loamy drain water and their consequent impact on soil and plants irrigated with effluent have been studied. The study reveals most of the parameter pH, BOD5 and COD at sampling station I was higher than station II. Waste water quality at both Stations I and II exceeded prescribed limits (BIS) for safe disposal of effluents into the surface water Samples of soil and vegetables from the land irrigated with loamy drain water has been collected and analyzed for Cu, Zn, Ni, Cr Pb and Cd. The different metals showed different enrichment factor for loamy drain water irrigated soil and are as follows: Cd 30% (max), Pb 26%, Zn 18%, Cr 5%, Cu 5%, Ni 2% (min). For plant samples collected at polluted sites are Ni 46% spinach (whole plant) (max), Zn 42% spinach (whole plant), Cr 39% spinach (whole plant), Cu 33% spinach (whole plant), Pb 20% potato tuber, Cd 20% potato tuber (min). The levels of Zn 145, Cu 5.25, and Ni 39.25 microg/ g in spinach, Pb 29.25, Cr 38. 25 and Cd 3.2 microg/g in potato tuber grown on polluted soil irrigated with contaminated drain water were found more than the reference value, which may create chronic health hazard problem to human and cattle through food chain in long run. Accumulation of toxic heavy metals may be build up in the agriculturally productive land where it is treated with contaminated effluent enrich with metals in turn bio-concentrated in the edible fodder/plants.     

Treatment of sugar industry wastewater using a combination of thermal and electrocoagulation processes

Sugar industries require a large amount of water for processing, and also generate large amounts of high-degree polluted wastewater. To maintain the water balance in the industry, it is imperative that effective treatment methods need to be devised to treat the wastewaters. The main aim of the present work is to treat the sugar industry wastewater by combined thermal and electro-oxidation methods with a metal and a catalyst based on ferrous material. Results showed a reduction of 75.6% of COD and 79.2% of colour content with thermal treatment, and 97.8% of COD and 99.7% of colour with combined thermal and electrocoagulation treatments under optimum conditions. These reduction levels are adequate for recycling limits.     

Improved space–time forecasting of next day ozone concentrations in the eastern US

There is an urgent need to provide accurate air quality information and forecasts to the general public and environmental health decision-makers. This paper develops a hierarchical space–time model for daily 8-h maximum ozone concentration (O₃) data covering much of the eastern United States. The model combines observed data and forecast output from a computer simulation model known as the Eta Community Multi-scale Air Quality (CMAQ) forecast model in a very flexible, yet computationally fast way, so that the next day forecasts can be computed in real-time operational mode. The model adjusts for spatio-temporal biases in the Eta CMAQ forecasts and avoids a change of support problem often encountered in data fusion settings where real data have been observed at point level monitoring sites, but the forecasts from the computer model are provided at grid cell levels. The model is validated with a large amount of set-aside data and is shown to provide much improved forecasts of daily O₃ concentrations in the eastern United States.     

Growth, yield and elements content of wheat (Triticum aestivum) grown in composted municipal solid wastes amended soil

A commercial formulation of composted municipal solid wastes (MSW) was used for amending soil at 0, 50, 100, 150, 200 and 250 kg ha⁻¹ in which wheat had been grown (field experiments) and element residues of amended soil and plant parts were enumerated. MSW amendment caused a significant improvement in soil quality. Growth (shoot length, leaf number, leaf area, tiller number, plant dry weight and chlorophyll contents of leaves) and yield (length of panicle, number of panicles per plant and grain yield per plant) of wheat increased gradually up to the MSW-amendment level of 200 kg ha⁻¹. Elements, Ni, Zn, Cu, Cd, Cr, and Pb accumulated in plants from MSW amended soil, but the degree of metal accumulation was the least in seeds in comparison to other plant parts (root, stem and leaf). Moreover, Ni, Zn, Cd and Pb, were in high concentration in all plant parts. It is recorded that the level of 200 kg ha⁻¹ MSW amendment caused better growth and yield of wheat, but progressive levels of metal accumulation in plant parts were recorded due to increase in amendment levels. Readers should send their comments on this paper to: BhaskarNath@aol.com within 3 months of publication of this issue.     

Treatment of wastewater by electrocoagulation: a review

The electrocoagulation (EC) process is an electrochemical means of introducing coagulants and removing suspended solids, colloidal material, and metals, as well as other dissolved solids from water and wastewaters. The EC process has been successfully employed in removing pollutants, pesticides, and radionuclides. This process also removes harmful microorganisms. More often during EC operation, direct current is applied and electrode plates are sacrificed (dissolved into solution). The dissolution causes an increased metal concentration in the solution that finally precipitates as oxide precipitates. Due to improved process design and material of construction, the EC process is being widely accepted over other physicochemical processes. Presently, this process has gained attention due to its ability to treat large volume and for its low cost. The aim of this study is to review the mechanism, affecting factors, process, and application of the electrocoagulation process.